SAFETY INSTRUCTIONS
SM6000
3 / 21
DELTA ELEKTRONIKA B.V.
rev. Nov. 2020
This marking shown on the product, its packing or its literature indicates that it should not be disposed with other
wastes at the end of its working life, but should be collected separately to recycle it responsibly to promote the
sustainable reuse of material resources.
WEEE (Waste Electrical & Electronic Equipment)
1.15
Correct Disposal of this Product
Applicable in the European Union.
1.10
Parts Substitutions & Modifications
Parts substitutions and modifications are allowed by authorized Delta Elektronika service personnel only. For repairs
or modifications the unit must be returned to a Delta Elektronika service facility.
1.11
Removal of (safety) covers
Safety cover(s) are used to cover potentially hazardous voltages.
Observe the following when removing safety cover(s):
Switch off the unit.
Disconnect the unit from the AC mains supply and from the DC power application.
Wait for 5 minutes to allow internal capacitors to discharge.
Unscrew the screws and remove the cover(s).
Always place the cover(s) back before connecting the unit to the mains supply again.
1.12
Environmental Conditions
The Delta Elektronika power supplies safety approval applies to the following operating conditions:
Indoor use
Ambient temperature
: -20 to 50 °C
Maximum relative humidity
: 95%, non condensing, up to 40 °C
: 75%, non condensing, up to 50 °C
Altitude
: up to 2000 m
Pollution degree
: 2
Caution risk of electrical Shock.
Instruction manual symbol. The instrument will be marked with this symbol when it is
necessary fort he user to refer to the instruction manual.
Protective ground conductor terminal.
Off (supply).
On (supply).
1.13
Canada
This product has been tested to the requirements of CAN/CSA-C22.2 No. 61010.1, second edition, including
Amendment 1, or a later version of the same standard incorporating the same level of testing requirements.
1.14
cTUVus