ELECTRICAL REQUIREMENTS
–
D
ELTA
H
EAT
G
AS
G
RILL
TO INSTALL AND SECURE POWER TRANSFORMER
Grill models with interior lights have a power transformer with an attached power supply cord.
This transformer must be secured in a dry location and away from the grill firebox and excessive
heat area.
a. In a base cart application, four mounting screws with nuts are provided at the bottom left rear
corner of the cart. If not provided, drill four holes using the transformer box as a template.
Secure the transformer box as shown. (Fig. 1)
b. In a built-in application secure the transformer box near the GFCI 120V outlet in a dry location
and away from the grill firebox and excessive heat area.
c. Make the transformer connections to the wire harness plug located at the left rear of the front
panel to the harness of the transformer box. (Fig. 2)
d. Plug-in the transformer’s power cord to the properly grounded GFCI 120V outlet.
e. A side burner plug to provide electrical power for side burner is located at the right rear of the
front panel. (Fig. 3)
AVERTISSEMENT
Instruction pour la mise à la terre electrique:
Cet appareil est muni d’une fiche à trois broches
(mise à la terre) afin de vous protéger des chocs
et doit être branché directement dans une prise
de courant à trois broches adéquatement mise à
la terre. Il ne faut pas couper ou enlever la
broche de mise à la terre de cette fiche.
WARNING
Electrical Grounding Instructions:
This outdoor gas cooking appliance is
equipped with a three prong (grounding) plug
for your protection against shock hazard and
should be plugged directly into a properly
grounded three prong outlet. Do not cut or
remove the third prong from this plug.
Fig. 1
ROTISSERIE MOTOR:
(Motor Specification: 40 lbs. / in; 0.5A; 15W; 60 Hz.)
The rotisserie motor requires 120 volt supply. Simply plug the motor into a properly grounded
GFCI 120 volt outlet at either side of the grill.
9
Fig. 2
Fig. 3
