- 15 -
4.2
L
OGGING
M
ENU
To access the
Logging
menu, open the main menu using the
SETUP
key. Using the
▲▼
◄►
arrows, select
Logging
and confirm with
ENTER
.
The parameter setting submenu for the logging sessions will be displayed.
You can set the data capture frequency (
Log interval
) and the automatic logging start (
Start/stop
time
).
T h
pt
e ca
r
nt r v l
th
m for ll pr ob
u e i e a is e sa e
a
es
.
With the “Log File Manager” you can handle the stored data sessions: printing, erasure.
4.2.1 Log Interval
Use this item to set the LOG interval (interval between two subsequent sample records): To enter
this setting, proceed as follows.
Once you have accessed the
LOGGING
submenu (previous par.) use the arrows
▲
▼
to select
Log
Interval
:
1.
Use the arrows
▲
▼
to select the interval duration from
a minimum of
2 seconds to a
maximum of one hour
;
2.
Press
ENTER
to confirm and return to the Logging menu;
3.
Press
ESC
to return to the
Logging
menu without making any change;
4.
Press
ESC
again to return to the main menu;
5.
Press
SETUP
to exit immediately from the menu.
These are the available values:
2, 5, 10, 15, 30 seconds, 1, 2, 5, 10, 15, 20, 30 minutes, and 1 hour.
4.2.2 Self Shut-off mode
The
Self shut-off mode
item controls the instrument’s automatic turning off during logging,
between the capture of a sample and the next one. When the interval is lower than 60 seconds, the
instrument will always remain on. With intervals greater than or equal to 60 seconds, it is possible
to turn off the instrument between loggings: it will turn on 15 seconds before the sampling and will
turn off immediately afterwards, thus increasing the battery life.
