- 23 -
4.3.1 The Baud Rate
The
Baud Rate
indicates the speed used for the serial communication with the PC.
To set the
Baud rate
, proceed as follows:
1.
Use the arrows
▲▼
to select the item;
2.
Press
ENTER
: You will get the following message:
3.
Use the arrows
▼▲
to set the value;
4.
Press
ENTER
to confirm and return to the previous page, or press
ESC
to cancel the change and
exit the menu item;
5.
Press
ESC
over and over to exit from the submenus;
6.
Press
SETUP
to exit immediately from the main menu.
WARNING:
The communication between instrument and PC (or serial port printer) only
works if the instrument and PC baud rates are the same.
If the USB connection is used, this
parameter value is automatically set.
4.3.2 Print Interval
To set the
Print Interval
, proceed as follows:
1.
Use the arrows
▲▼
to select the item;
2.
Press
ENTER
: You will get the following message:
3.
Use the arrows
▼▲
to set the value;
4.
Press
ENTER
to confirm and return to the previous page, or press
ESC
to cancel the change and
exit the menu item;
5.
Press
ESC
over and over to exit from the submenus;
6.
Press
SETUP
to exit immediately from the main menu.
The print interval can be set to one of the following fixed values:
0, 2, 5, 10, 15, 30 seconds, 1, 2, 5, 10, 15, 20, 30 minutes and 1 hour.
If the value 0 is set, PRINT works on command: The sending of data to the serial port is
performed each time the key is pressed
. With an interval from 2 seconds to 1 hour, continuous