- 6 -
1.
GENERAL
CHARACTERISTICS
The
HD32.8.8
and
HD32.8.16
are two
dataloggers
for
thermocouples
that can capture, log and
then send to a PC or serial printer the data coming from the 8 or 16 thermocouples. The instruments
can work with thermocouple of
type K, J, T, N, R, S, B or E.
During the measuring phase, the
connected probes must be of the same type
.
The probes position is detected during turn on: The probes are displayed in sequence according to
the same order of connection: First, the group A ones, then group B, etc.
The communication with the PC occurs through a multi-standard serial port RS232 or an automatic
detection USB 2.0. The memorization and printing interval, the logging start and end date, and the
communication parameters can be configured using the menu.
The captured data can be displayed on the PC using the
DeltaLog9
software (vers. 3.0 and later).
Through the RS232 serial port, you can transfer the data in real time to an 80 column serial printer.
NOTE: The set capture and print intervals are valid for all the probes.
Other user selectable/settable parameters are:
•
The units of measurement for the displayed temperature quantities: °C, °F, °K.
•
The system date and time
•
The display of the maximum, minimum, and average statistic parameters.
•
The relative value
REL
.
•
The data transfer speed via the serial RS232 port.
•
The setting, enabling and disabling of the password that locks the keyboard.
The instrument can store up to 64 LOG sessions (data capture) in two modes:
•
Automatic
: Setting the automatic start and stop dates;
•
Manual
: Pressing MEM to start and end the data capture session.
The flash memory has a total capacity of 800,000 recordings divided amongst all existing inputs.
The memory space can be handled in two modes:
•
When the available memory is full, the collected data are overwritten starting from the
oldest ones (circular memory),
•
The recording is stopped when the available memory is full.
