HD35
- 51 -
V1.12
6) ALRM_DELY_MENU (delay for alarm activation)
1)
Quantity 1_ALRM_DELY: delay for alarm activation of quantity 1. The type of
quantity depends on the data logger model.
2)
…
3)
Quantity n_ALRM_DELY: delay for alarm activation of quantity n. The type of
quantity depends on the data logger model.
4)
EXIT: returns to the main menu.
If the measured value drops below the lower threshold or exceeds the upper threshold, the
alarm is generated after the time set. The alarm is generated immediately if 0 is set. If the
alarm condition ends before the delay time is elapsed, the alarm is not generated.
7) MEAS_UNIT_MENU (measurement unit)
1)
Quantity 1_UNIT_MEAS: measurement unit of quantity 1. The type of quantity
depends on the data logger model.
2)
…
3)
Quantity n_UNIT_MEAS: measurement unit of quantity n. The type of quantity
depends on the data logger model.
4)
EXIT: returns to the main menu.
Note: the unit of measurement is changed only on the LCD; the data are always sent in
the unit of measurement set in the base unit.
8) LOG_MENU (logging)
1)
LOG_STAT: enables or disables the logging.
2)
LOG_CYCL: choice between cyclical management (the new data overwrite the old
ones when the memory is full) or non-cyclical management (logging stops when the
memory is full) of the data logger memory. Select YES for the cyclical management.
3)
LOG/RF_TIME: choice of logging and RF transmission interval (the two intervals
coincide). If it is higher than the measuring interval, the average of the measure-
ments acquired during the interval will be stored.
4)
MEAS_TIME: choice of the measurements acquisition interval. It is forced to the
value Log/RF_TIME if a higher value is set.
5)
LOG_DEL: deletes all stored measurements from the data logger memory. Select
YES to delete the memory.
6)
EXIT: returns to the main menu.
9) CLK_MENU (clock)
1)
YEAR: year. Read-only parameter if the instrument is connected to a base unit.
2)
MON: month. Read-only parameter if the instrument is connected to a base unit.
3)
DAY: day. Read-only parameter if the instrument is connected to a base unit.
4)
HOUR: hour. Read-only parameter if the instrument is connected to a base unit.
5)
MIN: minutes. Read-only parameter if the instrument is connected to a base unit.
6)
EXIT: returns to the main menu.
10) PSW_MENU (password)
1)
RST_PSW_LVL: exits the menu and deactivates immediately the password (the
password will not remain active for some minutes as it normally happens when ex-
iting the menu: you will need to re-enter the password even if you re-access imme-
diately the menu).
2)
SET_NEW_PSW: sets user-level password.
3)
EXIT: returns to the main menu.
Summary of Contents for HD35AP series
Page 120: ...HD35 120 V1 12 HD35EDLM TC...
Page 141: ...NOTES...
Page 142: ...NOTES...
Page 143: ...NOTES...
