6
1. Disconnect AC input from the charger, or from the
wall outlet. Wait 30 seconds for the input relay to
open.
2. While reconnecting AC input, press and hold the
Select Charge Profile Button. Hold the button
(approximately 10 seconds) through the light
check function until Error Indicator is on (in
amber) and Battery Charging Indicator (in green)
starts flashing.
3. Press and release the Select Charge Profile Button
to advance through charging profiles loaded on
the charger. The selected charging profile will
be displayed up to three times (e.g. “P-0-1-1” for
Profile 11).*
*Process will time out and profile will remain
unchanged if there is 15 seconds of inactivity, a
profile number is allowed to display three times, or if
AC power is cycled.
4. Once the desired charging profile is displayed,
press and hold the Select Charge Profile button
for 10 seconds to confirm selection and exit
Profile Selection Mode. When the charge profile
is confirmed, the Error Indicator and Battery
Charging INdicator lights will turn off, while the
blue AC Power Indicator remains lit. At this point,
the button can be released.
5. Press the Select Charge Profile Button to check
that the desired profile is selected.
2.0 IC650 Configuration
There are two ways to alter the configuration on the IC650 Charger:
1. Use the Select Charge Profile Button.
2. Use a pre-programmed USB flash drive.
Figure 1.Disconnect AC input from the charger.
2.1 Selecting A Charge Profile Using the ‘Select Charge Profile Button’
Figure 2. Reconnect AC input while holding the
Select Charge Profile Button.
Figure 3. Press the Select Charge Profile Button
to advance through the charge profiles. When the
desired charge profile appears, hold the button for 10
seconds to confirm your selection.