23
Possible errors
Potential errors are listed below, along with their causes and how to rectify them.
Error
Possible cause
Remedy
Remote control (2) does
not respond.
Remote control (2) is switched off .
Turn on remote control (2).
Batteries (5) incorrectly inserted.
Insert the batteries (5) correctly.
Batteries (5) are fl at.
Replace the batteries (5).
The quadcopter (1) does
not respond.
The batteries (5) in the remote control
(2) were incorrectly inserted or are
dead.
Check the batteries (5) and replace if necessary.
The rechargeable battery (8) in the
quadcopter (1) is fl at.
Charge the rechargeable battery (8).
The indicator lights (1e) do not fl ash or
light up.
Charge the rechargeable battery (8).
The quadcopter (1) is out of range.
Make sure that the distance between the remote control (2) and the quadcopter
(1) is not more than 50m.
The quadcopter (1)
cannot be controlled.
Too strong a wind or draught.
The quadcopter (1) is only suitable for calm conditions with no wind or up to force
3 winds.
The quadcopter (1) needs to be
calibrated.
Place the powered-on quadcopter (1) on a horizontal, level surface. On the
powered-on remote control (2), simultaneously slide the throttle (2h) to the left and
back, and the control lever (2l) to the right and back.
The indicator lights (1e) on the quadcopter (1) will flash for approx. 3 seconds.
Once the indicator lights (1e) are steadily illuminated, the calibration is complete
and the quadcopter (1) is ready to fly.
NOTE:
repeat the calibration if the quadcopter (1) still flies erratically in one
direction.
The quadcopter (1) will
not fl y upwards.
Not enough throttle.
Slide the throttle (2h) forward completely.
The rechargeable battery (8) is fl at.
Charge the rechargeable battery (8).
The rotor guards (1c) are
not securely fi xed.
Collision/crash
If a rotor guard (1c) becomes loose, tighten the screws again and double-check the
function and correct placement of the rotor guard (1c).
The quadcopter (1)
indicator lights (1e) fl ash
alternately.
Contact has not been established
between the quadcopter (1) and the
remote control (2).
Slide the throttle (2h) on the remote control (2) all the way forward, and then all
the way back.
This process establishes contact between the quadcopter (1) and the remote
control (2).
The rechargeable battery (8) is almost
fl at.
Switch off the quadcopter (1) and remove the rechargeable battery (8) so it can
be charged.
GB/IE
Summary of Contents for 345898 2004
Page 2: ...B G F H I J K E A C D ...
Page 3: ...5 L N M P O R Q ...
Page 53: ...55 ...
Page 54: ...56 03 09 2021 AM 11 32 ...
