22
GB/MT
Arm training (figure I)
For this exercise the article must stand in a
position so that the movement takes place at the
height of your breastbone or under your shoul-
ders. Ensure that your elbows are slightly bent in
the extended phase.
1. Place the article in front of you on a level,
stable and non-slip surface (e.g. at table
height), and sit upright with your back straight
in a relaxed position on a chair.
2. Place your feet on the floor shoulder-width
apart and tip your pelvis forwards.
3. Tense your abdominal muscles, straighten your
upper body and pull your shoulder blades
towards your spine. Keep your abdominal
muscles tensed throughout the exercise.
Keep your shoulders down.
4. Place the palms of your hands on the pedals
so that the pedal strap is above your hand.
5. ‘Cycle’ with your hands. Your head should
form the extension of your spine. Ensure that
you do not overextend your head.
Display function
The display has various modes that you can
select by pressing the button:
• SCAN: This mode displays the various display
modes alternately.
• TIME: This mode displays the duration of your
current training session.
• CNT: This mode displays the rounds
completed in the current training session.
• CAL: This mode displays the calories used
during your current training session.
Note:
calorie consumption is only an approxi-
mate reference value.
• R.P.M.: This mode displays the speed in rounds
per minute.
Note:
the display switches off automatically
after approx. four minutes when not in use.
Set value to zero
Press on the button for approximately four
seconds to reset the value to 0.
• Wear comfortable clothing to use the article.
However, please ensure that trouser legs or
sleeves are not too wide as they could be
caught in the pedals.
• Increase your speed slowly until you reach the
desired level.
• Only increase resistance slowly.
• Slow the speed to end use.
Use
Place the training article in front of you.
Start with easy training and low resistance.
Release the resistance screw to achieve this.
The tighter you turn the resistance screw, the
more difficult it is to turn the pedals.
Begin your training in the warm-up phase with
slow movements and low resistance.
Increase the speed and the resistance after 5-10
minutes. Reduce the speed and the resistance
again at the end of your training session.
Carry out some stretching exercises for the corre-
sponding muscles after your training session.
Leg training (figure H)
For this exercise the chair must be placed in front
of the article so that your knees always remain
slightly bent in the extended phase.
Ensure that you sit on the chair without support
and do not lean back.
1. Place the article on a level, stable and non-slip
area of floor, and sit upright and with a
straight back on a chair in a relaxed position
in front of the article.
Note:
ensure that the chair is stable and com-
fortable.
2. Place your feet on the pedals so that pressure
is placed on the centre of the soles.
3. Tip your pelvis forwards and tense your
abdominal muscles. Keep your abdominal
muscles tensed throughout the exercise.
4. Keep your upper body upright and pull your
shoulder blades to your spine. Your head
should form the extension of your spine.
5. ‘Cycle’ with your feet and avoid evasive move-
ments inwards and outwards.
