Delta 1914T Series, Quick Start Manual

             29   

A

Cleaning the Screen / Filtro de Limpieza: / Nettoyage du filtre

2

B

C

SHUT OFF WATER SUPPLIES. Check and clean screen (1) located in solenoid valve (2).

CIERRE LOS SUMINISTROS DE AGUA. Compruebe y limpie la pantalla (1) situada en la válvula 

electromagnética (2).

FERMEZ LES ROBINETS D’ALIMENTATION. Vérifiez et nettoyez l’écran (1) situé dans la vanne 

électromagnétique (2).

1

2

1

2

             33   

             30   

A.

Standard Water Line Connections 

Ensure all fittings and end connections are free of 

debris. Faucet fitting (1) is 3/8" compression. Loop 

tubing (2) if it is too long. 

Note: Recommended 

tubing minimum bend diameter is 8". Secure 

metal nut (3) on faucet tube to supply valve 

connection (4) and hand tighten, then tighten one 

additional turn with wrench. 

DO NOT 

OVERTIGHTEN.  

WARNING: Do not use pipe dope or other 

sealants on water line connections.

B.

 Custom Fit Connections

If you determine the PEX supply tubing for this  

faucet is too long and must be shorter to 

create an acceptable installation, be sure to 

read the instructions and plan ahead. When 

cutting the supply tubing the installer accepts 

the responsibility to do so in a way that allows 

a leak-free joint to be created. Delta is not 

responsible for tubing that is cut too short or 

cut in a way that will not allow for a  

leak-free joint.
For custom fit installations, you must use 

RP50952 sleeves supplied with model and nuts 

included on supply lines. 

Tube cut must be 

straight. See plastic sleeve installation 

instructions found in RP50952 and included in this 

document for more information. 
Secure metal nut (1) on faucet tube to supply valve 

connection (2) and hand tighten, then tighten an 

additional 2 turns with wrench. DO NOT 

OVERTIGHTEN. Repeat for other tube.

Potential Problems and Remedies

l

Tubing is not cut perpendicular to the axis of 

the tube: carefully make an additional cut, being 

careful not to cut the tube too short. 

l

Tubing is cut too short: buy a coupling union 

and a replacement supply line that mate 

together from a store. The coupling union end 

intended to connect to the faucet must mate to 

the standard 3/8" connection nuts and plastic 

sleeves supplied with the faucet.

l

The plastic sleeve or connection nut is lost: 

purchase a replacement nut and/or plastic sleeve 

that are designed to seal with PEX tubing. 

NOTICE: DO NOT use a metal sleeve, RP51243 

gasket (supplied with faucet) or ferrule in the 

place of the plastic sleeve supplied, it may not 

create a leak-free joint. 

     WARNING: Do not use pipe dope or other    

     sealants on water line connections.

1

2

3

1

2

A.

B.

OR

O

OU

4

1

2

Appendix / Apéndice / Annexe