20
SERVICE
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our website at www.deltaportercableservicenet.com.
You can also order parts from your nearest factory-owned branch, or by calling our Customer Care Center at 1-800-223-7278 to
receive personalized support from highly-trained technicians.
FREE WARNINg LABEL REPLACEMENT
If your warning labels become illegible or are missing, call 1-800-223-7278 for a free replacement.
ELECTRICAL HAZARD.
HIGH VOLTAGE EXISTS
WITHIN THIS ENCLOSURE.
RISK OF ELECTRIC SHOCK.
DISCONNECT POWER
BEFORE OPENING DOOR OR
SERVICING.
PELIGRO DE DESCARGA ELÉCTRICA.
DENTRO DE LA CUBIERTA HAY PIEZAS CON
ALTO VOLTAJE.
RIESGO DE DESCARGA ELÉCTRICA.
DESCONECTE LA ALIMENTACIÓN ANTES DE
ABRIR LA PUERTA O REALIZAR TAREAS DE
MANTENIMIENTO.
RISQUE D’ORIGINE ÉLECTRIQUE.
UNE TENSION ÉLEVÉE EST PRÉSENTE À
L’INTÉRIEUR DE CE COFFRET.
RISQUE DE CHOC ÉLECTRIQUE.
COUPER L’ALIMENTATION AVANT D’OUVRIR
LA PORTE POUR MAINTENANCE.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about Delta Machinery, its factory-
owned branches, or an Authorized Warranty Service Center, visit our website at
www.deltaportercable.com
or call our Customer
Care Center at 1-800-223-7278. All repairs made by our service centers are fully guaranteed against defective material and
workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at Delta Machinery, 4825 Highway 45 North, Jackson, Tennessee 38305 - Attention:
Product Service. Be sure to include all of the information shown on the nameplate of your tool (model number, type, serial number,
etc.)
kEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
WEAR ANSI Z87.1 SAFETY gLASSES WHILE USINg COMPRESSED AIR.
FAILURE TO START
Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the
outlet. Also, check for blown fuses or open circuit breakers in the line.
LUBRICATION & RUST PROTECTION
Apply household floor paste wax to the machine table, extension table, or other work surface weekly. Or use a commercially
available protective product designed for this purpose. Follow the manufacturer’s instructions for use and safety.
To clean cast iron tables of rust, you will need the following materials: a pushblock from a jointer, a sheet of medium
Scotch-Brite™ Blending Hand Pad, a can of WD-40
®
and a can of degreaser. Apply the WD-40 and polish the table
surface with the Scotch-Brite pad using the pushblock as a holddown. Degrease the table, then apply the protective
product as described above.
Summary of Contents for 22-610
Page 63: ...63 NOTES NOTAS ...
