8
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from
the shipping container(s). Remove the protective coating
from all unpainted surfaces. This coating may be removed
with a soft cloth moistened with kerosene (do not use
acetone, gasoline or lacquer thinner for this purpose). After
cleaning, cover the unpainted surfaces with a good quality
household floor paste wax.
CARTON CONTENTS
Your new 15" Planer is shipped complete in one box
(Fig. 2).
IMPORTANT:
Care must be taken when
removing the machine from the container. The machine
is very heavy and a minimum of four people will be
required to lift the machine (see the section
“LIFTING
THE MACHINE”
). Figure 3 Illustrates the loose items
supplied with your machine.
Fig. 2
Fig. 3
1
2
4
12
11
13
14
15
16
18
17
10
9
8
7
6
5
3
1 - Top cover
2 - M6 x 16mm hex flange screw (4) - for fastening
top cover to machine
3 - Cord clamp
4 - Knife setting gage
5 - Raising and lowering handwheel
6 - Key for raising and lowering handwheel
7 - Decal for raising and lowering handwheel
8 - M10 flat washer for raising and lowering
handwheel
9 - M10 hex nut for raising and lowering handwheel
10 - Handle for raising and lowering handwheel
11 - Open end wrench (10 and 12mm)
12 - Open end wrench (14 and 17mm)
13 - Hex wrench (6mm)
14 - Hex wrench (5mm)
15 - Hex wrench (3mm)
16 - Hex wrench (2.5mm)
*17 - M6 x 16mm Screw (2) - for fastening switch
bracket to machine
*18 - M6 flat washer (2) - for fastening switch bracket
to machine
*Supplied with three phase machines only
