19
Fig. 52
Fig. 53
ADJUSTING TABLE
EXTENSIONS AND
AUXILIARY FENCES
(FOR MODEL 36-250 ONLY)
Table extensions, one of which is shown at (A) Fig. 52,
are provided on each end of the saw stand to support
extra long workpieces. To move the table extensions,
loosen the two lock screws (B), pull out table extension
(A) to desired position and tighten lock screws (B). The
top surface of the table extension (A) is slightly lower
than the saw table and adequately supports just about
any size of workpiece that fits into the saw.
An auxiliary fence (C) Fig. 53, is provided on each table
extension and should be adjusted in line with the saw
fence (E) by loosening screw (D) and sliding auxiliary
fence (C) until it contacts the workpiece as shown.
N O T E : M A X I M U M L O A D P E R E A C H TA B L E
EXTENSION IS 50 POUNDS
.
B
B
A
E
C
D
USING AUXILIARY FENCE AS A STOCK STOP
(FOR MODEL 36-250 ONLY)
The auxiliary fence (A) can be used as a cut-off gage or stock stop when cutting a number of pieces
to the same length, as shown in Fig. 54. Loosen screw (B) and slide fence (A) forward to support and
stop the workpiece. Then tighten screw (B).
Fig. 54
B
A
Summary of Contents for 36-240
Page 32: ...32 NOTES...
