8
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
Wrench (Supplied)
2mm Hex Wrench (Supplied)
Open-end 7/16" Wrench (Supplied)
Assembly for this machine takes less than 30 minutes.
NOTICE:
The photo on the manual cover illustrates the current production model. All other illustrations contained in
the manual are representative only and may not depict the actual color, labeling or accessories and are intended to
illustrate technique only.
FUNCTIONAL DESCRIPTION
FOREWORD
Delta Model 36-422L is a high capacity 12" dual bevel compound miter saw equipped with a laser guide and designed
to cut wood and non-ferrous metals. This machine is supplied with design features that increase the cutting capacity.
Also, this model includes built in stops for cutting crown molding. This machine can cut 6" baseboard moulding mounted
vertically, crosscut 2" x 10" dimensional lumber at 90 degrees, miter 2" x 6" dimensional lumber at 45° both left and right,
and bevel 2" x 10" dimensional lumber left and right at 45°. It has positive miter stops at 0°, 15°, 22.5°, 31.62, and 45°
both left and right, and bevel stops at 0°, 33.9°, and 45° left.
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from all
unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline
or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household floor paste
wax. Place the machine on a firm, level surface with proper support of the workpiece. To release the head and move
it to the operating position, see
“MOVING CUTTINGHEAD TO THE UP POSITION”
and
“MOVING TABLE TO THE 0°
CUT-OFF POSITION”
sections in this manual.
CARTON CONTENTS
UNPACKING AND CLEANING
1
ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
1 - Miter Saw
2 - Dust Bag
3 - Dust Spout
4 - Wrench
5 - 2mm Hex Wrench
6 - 1/8 Hex Wrench
7 - Open End 7/16" Wrench
8 - Dust Shroud
9 - M4 Pan Head Screws
2
3
4
5
6
7
9
8
