8
ASSEMBLY
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
Phillips head screwdriver 12 mm wrench
This machine is heavy. Use two or more people when lifting.
1. Turn the stand (A) upside down (Fig 1).
2. Align the holes in the caster assembly (B) with the
holes in the plates on the stand. Place a 5/16”
flatwasher on a 5/16” x 3/4” hex-head screw. Place
this screw through the hole in the caster assembly.
and thread it into the hole in the stand. Attach the
other caster assemblies in the same manner.
3. Tighten the hardware by hand and then set it with
a 12mm wrench.
NOTE: This step requires two people.
Place all four stand posts (A) Fig. 3 into the four legs
(B) on the motor/blower assembly. Make sure that the
metal base plates (D) are arranged over the large holes
in the dust collector (C).
1. Place the motor/blower assembly with the motor (A)
Fig. 2 down.
2. Place a 3/8” (18 mm) flatwasher on the knob (B).
3. Align the holes on the legs (C) with the holes (D) in
the motor/blower assembly with the legs extending
up. Insert the knob through the hole in the legs
(C) and into the threaded hole in the motor/blower
assembly (D). Tighten the knob securely.
4. Repeat for all knobs on both legs.
ATTACHING THE LEGS ON THE MOTOR/BLOWER ASSEMBLY
ATTACHING THE CASTERS
ATTACHING THE STAND TO THE LEGS ON THE MOTOR/BLOWER ASSEMBLY
30 minutes to 1 hour
A
B
Fig. 1
Fig. 1
Fig. 2
D
C
B
A
B
A
D
C
Fig. 3
