Delta 50-775, Instruction Manual

7

Fig. 14

ASSEMBLING FILTER
AND DUST COLLECTION
BAGS TO DRUM

1.

Thread a 5/16" hex nut (A) Fig. 13, onto the end of

bag support rod (B). Thread rod into hole (E) and tighten
nut (A) against motor assembly  to hold support rod (B)
upright. Height of support rod can be adjusted after the
filter bag is in place. The hook in the support rod (B)
should be positioned over the drum.

2.

Hook the loop on the top of filter bag (F) Fig. 14,

onto the end of support rod (B).

3.

Position open end of filter bag (F) Fig. 15, over the

lip of drum (G). 

NOTE:

It may be necessary to adjust the

height of the drum support rod at this time. If adjustment
is necessary, loosen nut (A) Fig. 13, and rotate support
rod (B) as needed to obtain proper rod height to support
filter bag (F). Tighten nut (A) Fig. 13. Place locking band
(H) around the filter bag (F) and fasten filter bag to drum
by locking clamp (J) as shown in Fig. 15.

IMPORTANT:

Make certain band (H) is positioned in the channel of
drum (G) before locking clamp (J).

4.

Place the remaining locking band (H) Fig. 16, around

the dust collection bag (K). Position open end of bag
over the lip of drum (G) and fasten with locking clamp
(J). 

NOTE:

Make certain locking band (H) is positioned in

the channel of drum before locking clamp (J).

Fig. 13

Fig. 15

Fig. 16

A

B

E

F

B

J

H

G

F

H

G

K

J