8
Fig. 16
Fig. 17
Fig. 18
Fig. 19
12. Assemble the other end of drum support arm (T)
Fig. 16, to base (B). Place a 5/16" lockwasher onto a
5/16-18x5/8" hex head screw (W), insert the hex head
screw through drum support arm (T), and thread into
base (B). Repeat this process for the remaining hole.
NOTE:
Do not completely tighten mounting hardware at
this time.
13. Assemble the remaining drum support arm to the
opposite side of drum and base in the same manner.
Tighten all mounting hardware.
14. Fig. 17, illustrates the blower and motor assembly
mounted to the base.
ASSEMBLING FILTER
AND DUST COLLECTION
BAGS TO DRUM
1.
Hook the loop on top of filter bag (A) Fig. 18, into filter
bag support rod (B) as shown.
2.
Assemble extension rod (C) Fig. 19, onto the end of
filter bag support rod (B). Raise support rods (B) and (C),
with attached filter bag (A) and place end of support
rods into holes of bracket (D).
NOTE:
Flared end of filter
bag extension rod will prevent the rod from sliding
through bracket.
T
W
B
A
B
B
C
A
D
