21.
IMPORTANT: Make certain the rear end of the guard
basket frame (M) Fig. 22, is 3/8” away from the front of
the splitter (S) and tighten the two locking knobs (R)
and (H) Fig. 21.
22. To raise the guard basket (M) Fig. 23, above the saw
blade, simply lift up the hood by the dust port until guard
catch (T) engages hex head bolt (U) as shown in Fig 24. It
may be necessary to loosen hex head bolt (U) to allow the
guard catch (T) to fall back to engage bolt (U).
NOTICE: DO NOT LIFT THE GUARD BASKET FROM ANY
OTHER POINT EXECEPT THE DUST PORT!
23. To lower the guard basket assembly (M) pull forward on
guard catch (T) Figs. 24 & 25.
Fig. 22
9
Fig. 23
Fig. 24
Fig. 25
M
T
U
T
M
S
T
M
