Chapter 1 Introduction
|
C200 Series
1-1
Chapter 1 Introduction
Receiving and Inspection
After receiving the AC motor drive, please check for the following:
1. Please inspect the unit after unpacking to assure it was not damaged during shipment. Make sure
that the part number printed on the package corresponds with the part number indicated on the
nameplate.
2. Make sure that the voltage for the wiring lie within the range as indicated on the nameplate. Please
install the AC motor drive according to this manual.
3. Before applying the power, please make sure that all the devices, including power, motor, control
board and digital keypad, are connected correctly.
4. When wiring the AC motor drive, please make sure that the wiring of input terminals “R/L1, S/L2,
T/L3” and output terminals”U/T1, V/T2, W/T3” are correct to prevent drive damage.
5. When power is applied, select the language and set parameter groups via the digital keypad
(KPE-LE02). When executes trial run, please begin with a low speed and then gradually increases
the speed untill the desired speed is reached.
Nameplate Information
MODEL VFD007CB43A-20
:
INPUT :
Normal Duty: 3PH 380-480V 50/60Hz 4.3A
Heavy Duty: 3PH 380-480V 50/60Hz 4.1A
OUTPUT :
Normal Duty: 3PH 380-480V 3A 2.4KVA 1HP
Heavy Duty: 3PH 380-480V 2.9A 2.3KVA 1HP
FREQUENCY RANGE :
Normal Duty: 0-600Hz
Heavy Duty: 0-600Hz
Version:VX.XX
007C BEAIT1080001
DALTA ELECTRONICS. INC.
MADE IN x x x x x x x x
E nclosu re type (IP X X )
A c Drive Mo de l
In pu t Vo lta ge/Curre nt
Outp ut Vo ltag e/Cu rren t
F req ue ncy Ra ng e
F irmware Version
Ce rtification s
S eria l Numbe r
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com
