DX-3001 Series Industrial Cloud Router
3-28
_3
Description
Default
AS series PLCs
Other:
Use this option for non-Delta PLCs.
Address Type
Depending on the selected controller type change:
Delta PLC:
The address type is "D"
Other:
The address type is "W"
D
Slave Starting Address (decimal)
Set up the slave starting address for read/write the
registers in a PLC.
Delta PLC:
Enter the internal D register number. If
you need to read / write D0, please enter 0 here.
Other:
Enter the hexadecimal actual address. For
example: Holding Register: 400100, take 0100
(decimal) that is 64 (hex).
Supports the Holding Register :
400001~465535
(Decimal)
N/A
Device Starting Address (decimal)
Set up the device starting address (decimal, input range
is from $2048 to $4095). $ specifies that the match must
start at the beginning of a Device Starting Address.
N/A
Length (1-123)
Here displays the number of the continuous address
followed by the default mapped address.
N/A
Add Mappings
Click the button to add mappings; the data mapping
can be set to 200.
N/A
Edit
Click an item of register mapping forms that can be
edited.
N/A
Operation
The added mappings can be deleted here.
N/A
Serial Server –
TCP Client
TCP Alive Check Time
Set up the keep alive time of TCP connection. Range
from 0 to 99 minutes.
0: Never disconnect the connection
1 ~ 99: Disconnect the TCP connection after the idle
time meet the set value
7
Destination IP address and port
Set the IP address and port of the serial server. Up to 4
192.168.1.100
Summary of Contents for DX-3001 Series
