Delta (Model 31-300), Instruction Manual

16

16

DISCONNECT MACHINE FROM POWER SOURCE

Fig. 33

Fig. 32

ADJUSTING SANDING DISC TABLE 90 DEGREES TO DISC

TILTING THE DISC SANDER TABLE

DISCONNECT MACHINE FROM POWER
SOURCE.

The table (A) can be tilted 45 degrees down (Fig. 34), by
loosening the lock handle (B), tilting the table (A), and
tightening lock handle (B). The degree of tilt is determined by
the scale and pointer.

Fig. 34

1.

Loosen the disc table lock handle (A) Fig. 32, and move the table (B) Fig. 33 until the it contacts the stop. Tighten
the lock handle (A) Fig. 32. 

2.

Place a square (E) Fig. 33 on the table and against the sanding disc. See if the table is 90 degrees to the disc.

3.

To adjust, loosen the lock handle (A) Fig. 32, and tighten or loosen the screw (F) Fig. 32 until the table is 90 degrees
to the disc.

4.

The stop (F) Fig. 32 ensures that the table can rapidly return 90 degrees to the disc after the table has been
tilted.

5.

Adjust pointer, if necessary.

ADJUSTING DISC TABLE MITER GAUGE SLOT PARALLEL TO SANDING DISC

DISCONNECT MACHINE FROM POWER
SOURCE

1.

With the table (A) Fig. 35 positioned 90 degrees to the
disc, place a square (B) in the miter gauge slot with the
blade of the square touching the sanding disc.

2.

Use a pencil to mark the disc where the blade contacts it.
(Fig. 35).

3.

Rotate the disc to the other end of the table. Use a square
to check the distance between the miter gauge slot and
the mark on the disc made in 

STEP 3

.

Fig. 35

A

B

E

F

A

B

A

B