10-ENG
D25235
1.
Place the air compressor on on a
solid, level surface.
2.
Mark the surface using the holes
in the air compressor feet as a
template.
3.
Drill holes in the surface for the
concrete anchors. Install con-
crete anchors.
4.
Line-up holes in surface with
holes in air compressor feet.
5.
Place the (4) washers (not sup-
plied) between the floor and air
compressor feet. If needed, solid
shims may be placed between
the washers and floor to evenly
distribute weight on all four feet.
See next figure.
6.
Place the (4) 3/8" lag screws
through the air compressor feet,
washers, shims, and into the
anchors.
7.
Torque 3/8" lag screws to 7-10
ft.-lbs.
Anchoring of the Air
Compressor
Excessive Vibration
can weaken the air
tank and cause an explosion. The
compressor must be properly
mounted.
The air compressor MUST be bolted
to a solid, level surface.
Hardware needed:
4 - Concrete anchors (not sup-
plied)
4 - 3/8" Lag screw to fit con-
crete anchors (not supplied)
4 - 5/8" Washer (not supplied)
- Shims (if needed)
Location of the Air Compressor
•
Locate the air compressor in a
clean, dry, and well ventilated
area.
•
Locate the air compressor at
least 12" away from the wall or
other obstructions that will inter-
fere with the flow of air.
•
Locate the air compressor as
close to the main power supply
as possible to avoid using long
lengths of electrical wiring.
NOTE:
Long lengths of electrical
wiring could cause power loss to
the motor.
•
The air filter must be kept clear
of obstructions which could
reduce air flow to the air com-
pressor.
HOW TO SET UP YOUR UNIT
3/8" Lag
Screw
(not supplied)
5/8" Washer
(not supplied)
Shim Under
Washer
(not supplied)
Concrete Anchor
(not supplied)
Surface Line
INSTALLATION
