12
INSTALLING OR REMOVING BATTERY PACK
Always set the trigger
switch to the locked OFF position
when installing or removing the
battery pack.
TO INSTALL BATTERY PACK:
Align
rails (A) Fig. 4, on battery pack with
slots on tool and push battery pack
onto tool until it locks in place.
TO REMOVE BATTERY PACK:
Depress the battery release button (B)
Fig. 4, and pull battery pack out of
tool.
NOTE: This tool is shipped completely assembled. No assembly
time or tools are required.
LOADING FASTENERS
REMOVE BATTERY
PACK. ONLY USE APPROVED DELTA
FASTENERS.
1.
Pull down on the nail pusher (A)
Fig. 5, until it locks in the open
position as shown in Fig. 6.
2.
Insert a strip of approved
fasteners, (B) Fig. 7. Orient
fasteners with points down, and
in contact with the bottom of the
magazine.
3.
Pull nail pusher (A) Fig. 8,
completely to the rear, rotate
lever to the right and allow nail
pusher to slowly slide forward to
contact nails.
Fig. 4
A
A
B
ASSEMBLY
Fig. 6
Fig. 8
Fig. 7
A
B
A
Fig. 5
A
