5
8
Soap / Lotion Dispenser Installation
Remove the bottle (1). Separate head (2)
from body assembly (3). Make sure gasket
(4) is properly seated in the base of the
body assembly. Insert body assembly
through selected hole in sink. Secure body
assembly to sink with nut and gasket (5).
From under the sink screw the bottle (1)
onto the body assembly shank, then
attach head assembly.
Note:
To fill, lift
the head and pump assembly out of the
bottle and pour not more than 8 oz.
into bottle.
DO NOT remove the bottle
each time as this weakens the neck.
Use a funnel to help prevent spills. Pull
pump and head assembly out occasion-
ally to soak and pump warm water
through pump to remove soap build-up.
Note: Initially it may take up to 12
pumps to bring soap to the pump tip.
5
4
3
1
2
