Installation guide
Page 27
5.1.3
Cabling recommendations
It is recommended to use quality cables to avoid signal perturbations and unexpected behaviour.
5.1.3.1
For SDI reception and streaming:
Coaxial RG6 or RG59 (75 Ohms) cables are required and low loss cables are recommended for 3G (ex.
BELDEN 1694A, 1505A or 1855A), for 6G (ex. BELDEN 1855A) and for 12G (ex. BELDEN 1855R).
5.1.3.2
For IP reception and streaming (SFP+ 10Gbit Ethernet transceiver):
10GbE SDP+ transceiver must be compatible with the "SFI" electric interface and work at
10.3125Gbps (SFF Committee SFF-8431: Specifications for Enhanced 8.5 and 10 Gigabit Small
Form Factor Pluggable Module “SFP+”).
SFP+ 10GbE optical transceiver modules (10GBASE-SR, -LR or –ER)
SFP+ Direct Attach copper Cables (Cu passive or active copper cable
assembly). Warning: Cu can only be used on systems with common grounds.
Connecting systems with different ground potential with SFP+ direct attach cable
results in a short and may cause damage.
SFP+ Direct Attach optical cable.
5.1.3.3
For DisplayPort reception and streaming
The following table describes the characteristics a DisplayPort cable needs having depending on the
product:
Product Name
DisplayPort Standard
FLEX-dp 10
DisplayPort 1.2
FLEX-dp 01
DisplayPort 1.2
5.1.3.4
For HDMI reception
The following table describes the characteristics a HDMI cable needs having depending on the
product:
Product Name
HDMI cable capabilities
DELTA-h4k-elp 20
HDMI 1.4 Ready
DELTA-h4k2-elp 20
HDMI 2.0 Ready
FLEX-hmi
HDMI 2.0 Ready
DELTA-12G1c-hmi10-elp
HDMI 2.0 Ready
Summary of Contents for A-FLEX-1M
Page 1: ...Installation guide Page 1 Installation Guide for End Users Hardware and Software...
Page 53: ...Installation guide Page 47 9 3 DoC Notices...
Page 54: ...Installation guide Page 48...
Page 55: ...92 6 rue Gilles Magn e B 4430 ANS BELGIUM 32 4 239 78 81 contact deltacast tv www deltacast tv...