86
GB
then press the On/Off switch (11), the
chainsaw runs with highest speed.
Release the switch-on block again
5.
The power saw switches off when you
release the On/Off switch (11) again.
Switching for continuous running is not
possible.
Checking the chain brake
The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
1. Place the chainsaw onto a solid,
flat surface. It must not contact
any objects.
2. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (8).
3. Hold the chainsaw firmly with
both hands, with the right hand
on the rear handle ( 1) and the
left hand on the front handle
(
8). Thumb and finger must
close securely over the handles.
4. Turn on the chainsaw.
5. Activate the chain braking le-
ver (3), with running motor, with
the left hand. To do so, push the
chain braking lever/front hand
protection (3) away from the front
handle (8).
Chain should stop abruptly.
6. Once the chain brake is work-
ing properly, release the on/off
switch (10) and the chain brake.
If the chain brake does not func-
tion correctly, you must not use
the chainsaw. A slack saw chain
leads to danger of injury. Return
the chainsaw to our Service-
Center for repair.
Make sure you have a secure
stance. Before starting, ensure that
the electric chainsaw is in contact
with no objects.
Caution! Saw can oil up, see notes
on Operation startup.
Indicator charge level
Press the „Press“ button on the right of
charging level indicator ( 19b), in order
to check the status of the battery.
The number of illuminated LED lights
shows the charge level of the battery.
Removing / inserting the
battery
1. To remove the battery (19) from the
appliance, press the release button
( 19a) on the battery and pull out
the battery.
2. To insert the battery (19), place it on the
guide track (17) and push it back into
the appliance. It will audibly snap in.
Switching on
1. Check before the start, whether suffi
-
cient chain oil is in the tank and, if nec-
essary, refill with chain oil (see Chapter
“Operation startup”).
- the charge status of the battery
(see ).
2. Release the chain brake, where you
shift the brake arm (3) back against
the front grip (8).
3. Hold the chainsaw firmly with both
hands, with the right hand on the rear
grip (1) and the left hand on the front
handle (8). Thumb and finger must
close securely over the handles.
4. For switching on, activate the switch-
on block (10) with the right thumb and
