H4KFWSD08DPX User Manual
6
/
26
Start
DeltaPix InSIght
software or 4K
View App
and check the configuration.
Normally, active H4KFWSD08DPX cameras are automatically recognized.
4.4
Connecting camera to the PC with Gigabit Ethernet port (coming soon)
This application uses the camera as the a network camera. User must configure the IP of
the camera and PC manually and ensure their IP addresses are in the same net. The
subnet mask and gateway of the camera and PC must be the same.
Figure 7-3 Connecting the H4KFWSD08DPX Camera with Ethernet Cable to the PC
Start the camera according to Sec. 7.1 after the camera is running, clicking the
button on the
Camera Control Toolbar
at the bottom of the video window, a small
window called
Settings
will pop up as shown below on the left side, clicking the
LAN
property page, uncheck the DHCP item. Input the
IP Address
,
Subnet Mask
and
Default Gateway
for the camera. Designate the
Internet Protocol Version 4 (TCP/IPv4)
Settings
page’s IP address on the PC with similar configuration as shown below on the
right side but with different
IP address
.
