INSTALLATION
Set up an electrical multi-duct conduit in the middle of the foundation of the barrier,
corresponding to the central hole (corrugated - diameter 25 - 50mm).
INSTALLATION WITH BASE PLATE
(OPTIONAL)
Take the floor plate and bend the brackets
as needed. Dig a suitably sized hole in the
ground. Insert the electrical conduit into the
cable conduit hole of the floor plate. Level
and cement the floor plate.
Place the barrier on the floor plate and
fasten it with the self-locking M12 nuts
supplied.
Open the cover with the key.
Insert the handle provided in the pin and turn until reaching the desired opening.
Please note that when the cover is opened
the operator goes into block
INSTALLATION WITHOUT BASE PLATE
Place the barrier and block it through the
four holes present internally on the basis.
MANUAL OPENING
Fixing holes
1
2
3
4
Base plate
Cable conduit
hole
Nuts
Brackets
Handle
