3.2 Transmitter Memorizing
3.3 System Learning And Led Display
To complete the system learning, follow the instructions below:
Step1: Press “SET”; then press “SET” + “DOWN” for 3 seconds, and the LED display shows “LEA”
Stop2: Press button (A) on time, the LED display should shows “ARN”
Step3: The gate will goes to Auto-learning, please wait for the learning process to be completed
Press “RF Learn” button for 2 seconds, and the LED3 is on; then press the transmitter button (A); the LED3 will blink
twice and then be off. The transmitter learning is completed.
A
B
A
B
LED Display
Programmable Functions
“N-L”: The Boxer system learning is not done.
“LEA”: Enter learning mode and then wait for learning instructions.
“ARN”: The system learning is in progress.
The Auto-learning process of gate moving:
“Gate open to the end- stop close to the end- stop.”
LED 3
2 Sec
LED 3
blink twice
LED 3 OFF
1
Press
1~3 Sec
Press
3 Sec
Push
1
2
3
4
5
6
2
3
12
13
14
LED1
LED2
LED3
ON
OFF
14
LED1
LED2
LED3
ON
OFF
2
3
4
5
6
7
8
9
10
11
12
13
14
LED1
LED2
LED3
ON
OFF
“RUN”: The Boxer system is in normal operation
To program, press SET button for 3 seconds, when the LED display change from RUN to F1,
press UP or DOWN to change function settings (F1 to FA). Then press SET to enter the sub
function within each group, press UP or Down to select sub functions and press SET for
confirmation.
! CAUTION: Before proceeding to system learning, the transmitter memorizing process has to be completed.
INSTRUCTIONS PL500 SLIDING GATE OPENER USER MANUAL
7
