9
SMART ALLIGATOR CLIPS
The smart alligator clips contain a single Amber/Green LED along with a warning
buzzer for Faults and Error protection:
1) If connected correctly the LED on the smart alligator clips should turn
green.
1) Standby Mode – Clips are not connected – The Green LED Flashes.
2) Vehicle battery voltage to LOW - Amber LED On, buzzer is beeping
3) Vehicle battery voltage to HIGH - Amber LED On, buzzer On solid.
4) Alligator clips connected to vehicle battery in reverse polarity. (Red clip to
Black negative terminal, Black clip to Red positive terminal). Amber LED
On, buzzer is beeping.
5) Short circuit protection - Amber LED On, buzzer is beeping.
6) Over heat protection – Amber LED is Flashing, buzzer is beeping.
CHARGING THE VEHICLE JUMP STARTER & PORTABLE POWER BANK
1) Use the supplied micro USB cable and wall charger if needed to charge the
Vehicle Jump Starter & Portable Power Bank.
NOTE:
While charging all of the other features and functions are NOT
active.
2) When charging “IN” will appear above the percentage of charge digits and
the second percentage digit will flash on the LCD display.
3) Once the internal battery level has reached 100% the charge is complete
and the unit will turn off after 10 seconds.
4) The battery level should be checked and charged every three (3) months.
5) DO NOT use any other charger to charge this Vehicle Jump Starter &
Portable Power Bank.
6) Doing so can damage the internal battery and also be very dangerous.
7) When charging the internal battery, work in a well ventilated area and do
not restrict ventilation in any way.
10
WIRELESS PHONE CHARGING
1) Press the ON/OFF button, the LED display will illuminate showing the
Icon flashing.
2) Place the back of your phone onto the unit. The Icon will turn solid and
your phone will then be charging.
3) Make sure there are no extra obstructions (apart from the case) on the
back of your phone.
CAUTION
1) The device shall be stored indoors and protected from the elements.
2) The unit shall not be charged outdoors.
3) When in use, steps should be taken to reduce the exposure to rain, sleet,
snow, and the like.
USB PORTS
1) There are three (3) USB ports contained in your Jump Starter & Portable
Power Bank. Once your device is connected you must press the ON/OFF
button to activate charging.
a. Standard USB Output port - 5VDC/2.4Amp. Used to charge your cell
phone, tablet etc.
b. Type – C USB, In (Out) port – 5VDC/3Amp. This can power a tablet,
power pack, smart phone, camera etc.
c. Micro USB Input port – 5VDC/2A. This port is for charging your Jump
Starter & Portable Power Bank. Only use the supplied cable to charge
your Jump Starter & Portable Power Bank.
LED FLASH LIGHTS
1) To turn the LED lights ON simply hold the ON/OFF Button down for at least
two (2) seconds.
2) To turn the LED lights OFF hold the ON/OFF Button down for at least two
(2) seconds.
