6
Installation
As you carefully unpack the machine, check to make sure all components were delivered and are
in good working order. Refer to
Figure 1
in this manual for reference to the following pieces:
• M27 Manual
• Complete Work Table Assembly (17145FA) with a Right-Hand Side Paper Guide (A1178),
a Left-Hand Side Paper Guide (A1185), Work Guide Screws (63) Back Gauge Bar
Assembly (17161A), Back Stop Gauge (G30164A) and Plate (17149).
• Pivot Bar (17146) and set of Table Lock Pins (16148)
• Assembled Spool Bar (17280) and Guide Spring Bar (17289) with Brackets (17282)
• Wire Spool (for each head shipped), along with a Spool Stud (7693), Plastic Washer
(M11009), Tension Spring (7690), Set Collar (7691) with Thumb Screw (P2731),
9/16 Washer (PG10271), Spool Washer (2245), 3/8 Washer (PW38) and Hex Nut (HN3816)
• Wire Guide Spring (18150A) for each Stitcher Head shipped.
• Driver Release Pin (5160) for each 18D Head shipped.
• Wire Guide Spring Plate Assembly (G20278AA), a set of 2.0, 2.5, 3.0 and 5 mm Hex Key
Wrenches (G20361, G20360, G20362 and G20374) and an Open End Wrench (G20364)
for each G20 Head shipped.
• Upper Wire Tube (G20581) for each G20 Head shipped.
• Stitch Samples
Carefully inspect the condition of the shipping container before unpacking your M27
Stitcher. If the container is broken, damaged or has been tipped over and there is evidence
that the machine may be damaged, immediately notify the carrier who delivered the machine
and the DeLuxe Stitcher Graphic Arts Representative from whom the M27 was purchased.
Pre-Inspection
Inspection
Please take a few moments to fill out the registration card located on page 42 prior to beginning
installation.
Pre-Installation
Summary of Contents for M27 Series
