Demix Zenit Powertools CD-18 E, Instruction Manual

6

should switch to the red LED-indicator 

«ON». After charging process is finished 

the battery charger will switch off auto-

matically and the «OFF» LED-indicator 

will light (the LED-indicator «ON» will 

turn off).

NOTE

Remove the battery from the battery char-

ger. As the internal chemical substance of 

new batteries and batteries that have not 

been used for an extended period is not 

activated, the electric discharge may be 

low when using them the first and second 

time. This is a temporary phenomenon 

and normal time required for recharging 

will be restored by recharging the batter-

ies 2-3 times.

Charging time may be longer depending 

on the surrounding temperature and bat-

tery conditions.

4. Unplug charger from receptacle.

5. Hold the charger firmly and remove 

the battery.

how to Make Batteries per

-

forM lonGer

1. Recharge the batteries before they 

become completely exhausted. When you 

feel that the power of the tool becomes 

weaker, stop using the tool and recharge 

its battery. If you continue to use the 

tool and exhaust the electric current, the 

battery may be damaged and its life will 

become shorter.

2. Avoid recharging at high temperatures. 

A rechargeable battery will be hot  im-

mediately after use, its internal chemical 

substance will deteriorate, and the battery 

life will be shortened. Leave the battery 

and recharge it after it has cooled for a 

while. 

CAUTION

If the battery is recharged when it is 

warm due to battery use of exposure 

to sunlight, the pilot lamp may light in 

green. In such a case, let the battery cool 

before charging.

When the pilot lamp flickers rapidly 

in red, check and take out any foreign 

objects in the charger’s battery installa-

tion hole. If there any foreign objects, it 

is probable that the battery or charger is 

malfunctioning. Take it to the authorized 

service center.

prior to operation

1. Check the area to make sure that it is 

clear of debris and clutter.

Check whether working conditions meet 

the safety measure.

2.Tightening torque adjustment

• Tightening torque should correspond in 

its intensity to the screw diameter. When 

too strong power is used, the screw head 

may be broken or be injured. Be sure to 

adjust the clutch dial position according 

to the screw diameter.

• Tightening torque indication.  The 

tightening torque differs depending on 

the type of screw and the material being 

tightened. The unit indicates the tighten-

ing torque with the numbers “1,4,7…16” 

on the clutch dial, and black dots. The 

tightening torque at position “1” is the 

weakest and the torque is the strongest at 

the highest number.

• Adjusting the tightening torque. Rotate 

the clutch and line up the numbers 

“1,4,7…16” on the clutch dial, or the dot, 

with the triangle mark on the outer body. 

Adjust the clutch dial in the weak or the 

strongest torque direction according to 

the torque you need.