Demix Zenit Powertools CD-18 E, Instruction Manual

The bit rotates clockwise (viewed from 

the rear side) by pushing the R-side of the 

selector button. The L-side of the selector 

button is pushed to turn the bit counter-

clockwise.

CAUTION

When using the cordless drill follow 

these rules:

• continuous use of the drill should not 

exceed 15 minutes;

• do not allow mechanical damage 

(strikes, falls etc.); 

• protect the drill from external sources of 

heat and chemically active substances, as 

well as liquid and objects penetration;

•  before disconnecting the tool from the 

power source turn off the On/Off switch;

• check the engine temperature, do not 

allow overheating; 

• change the rotation direction only after 

switching off the tool and complete stop 

of rotating parts.

Inobservance of these rules will make 

warranty void! 

WARNING! Repair, modification 

and check of ZENIT power tools should 

be performed only in authorized service 

centers ZENIT. While use or maintenance 

of power tools follow all safety rules and 

standards.

NOTE

Zenit Power Tools are constantly being 

improved and modified to incorporate the 

latest technological advancements.

Accordingly, some parts may be changed 

without prior notice.

CAUTION

Ratchet sound of the clutch dial for a 

long period of time may cause screw 

breakage due to excessive tightening.

3. Mounting and dismounting of the bit

• Mounting the bit 

Loosen the sleeve by turning it toward 

the left (in the counterclockwise direc-

tion as viewed from the front) to open the 

clip on the keyless chuck. After inserting 

a driver bit, etc., into the keyless drill 

chuck, and tighten the sleeve by turning it 

toward the right (in the clockwise direc-

tion as viewed from the front).

If the sleeve becomes loose during opera-

tion, tighten it further.

The tightening force becomes stronger 

when the sleeve is tightened.

• Dismounting the bit. Loosen the sleeve 

by turning it toward the left (in the coun-

terclockwise direction as viewed from the 

front), and then take out the bit etc.

NOTE

If the sleeve is tightened in a state where 

the clip of the keyless chuck is opened 

to a maximum limit, a click noise may 

occur. This is the noise that occurs when 

the loosening of the keyless chuck is 

prevented and is not a malfunction.

CAUTION

When it is no longer possible to loosen 

the sleeve, use a vise or similar instru-

ment to secure the bit. Set the clutch 

mode between 1 and 7 and then turn the 

sleeve to the loose side (left side).

4. Confirm that the battery is mounted 

correctly. 

5. Check the rotational direction