5
9. Never insert any objects into the battery
charger’s air vents. Electric shock or dam-
age to the battery charger may result.
10. When inserting the bit into the keyless
chuck, tighten the sleeve. If the sleeve is
not tightened, the bit may fall and cause
bodily injury.
description
1. Clutch dial
2. On\Off switch
3. Battery
4. Direction selector
5. Shift knob
6. Diode light
technical specifications
Model
cd-18 profi
Voltage
18 V
Battery capacity
1500 mAh
Charging time
1 hour
Speed
0-450/0-1050 rpm
Chuck size
10 mm
applications
Drilling of bricks, screwing and unscrew-
ing of screws and bolts. Drilling of vari-
ous metals and wood.
Battery installation and
reMoval
1. How to remove the battery
Hold the handle firmly and press the bat
-
tery letch for the battery removal.
CAUTION
Never short-circuit the battery.
2. How to install the battery
Install the battery, observing the polarity.
charGinG Method
Before using the cordless drill charge the
battery.
1. Connect the charger’s power cord
into a receptacle. When the power cord
is connected, the charger’s pilot lamp
should not light.
2. Insert the battery into the charger.
Firmly insert the battery into the charger
until the line is visible and check the
polarity.
CAUTION
If the battery is installed incorrectly, not
only the battery will not charge, but also
the battery charger may malfunction, for
example, compression terminals may
become deformed.
3. Charging. To start charging press the
«SET» button. After pressing thee «SET»
button the green LED-indicator «OFF»
should switch to the red LED-indicator
«ON». After charging process is finished
the battery charger will switch off auto-
matically and the «OFF» LED-indicator
will light (the LED-indicator «ON» will
