1. Getting acquainted with your High Pressure Cleaner
C-150-200D V16
Page 4
Unpacking
Remove the High Pressure Cleaner and its accessories from the packing material. For
transport and packing reasons some accessories may be supplied disassembled.
Make sure all components are present:
High-pressure machine itself
Handle bar (partly attached)
Wing nuts for the handle bar
Electrical cord (attached)
High pressure hose with Spray-gun trigger
Double barrel lance (disassembled)
Water inlet male hose coupling
Installation
-
A
ttach the handle bar (pos 23, page11) to the machine using the wing nuts and bolts supplied;
align the handle bar according to the cabinet molding.
-
M
ount the high-pressure hose on to the High Pressure Cleaner (pos. 30 page 18) by pulling
back the retainer (pos. 24) on the high-pressure hose coupling, while sliding it on the male
part (pos. 30 page 18) positioned on the front of the High Pressure Cleaner.
-
A
ssemble the double barrel spray-lance (pos. 1 page 22). To mount the assembled spray-
lance on to the Spray-gun trigger, pull forward the front of the Spray-gun trigger while
sliding in the male swivel coupling part (pos. 13 page 22) of the spray-lance.
-
P
repare the water supply for the High Pressure Cleaner, by attaching a hose to the supplied
low pressure inlet male-coupling. Connect the other end of the water supply hose to a
potable water tap. Open the tap.
Notice:
Connection to the public mains water supply according to regulations.
-
B
efore starting the machine, bleed out air by pulling the trigger-gun handle until any air has
escaped the inlet hose.
-Turn on the power of the engine.
-
T
he high pressure cleaner is now ready for operation. The spray-gun lance is affected by a
recoil force during operation – therefore keep a firm grip with both hands on the Spray-gun
handle and the lance. Press the trigger and start cleaning.
-
T
he pressure can be regulated by turning the high-pressure cock on the spray-gun lance.
When using chemical injector, pressure must be adjusted to low.
Do Not run the High Pressure Cleaner without sufficient potable water supply
it can cause cavitations and serious damage to internal pump parts. Do not let
the machine recycle the water (running with Spray-gun trigger not activated)
for more than a few minutes; this can cause serious damage to the seals.
CAUTION
