© DENAFRIPS CO. LTD. & VINSHINE AUDIO PTE. LTD. (SINGAPORE)
ALL RIGHTS RESERVED
1.
INSTALLATION & SAFETY INSTRUCTIONS
This CDT is designed and built to provide trouble-free performance, but as with all electronic
devices it is necessary to observe a few precautions:
Unpack the CDT carefully.
Position the CDT on a stable, horizontal surface, i.e. sturdy rack.
The CDT supports voltage 100-250VAC worldwide voltage. Please connect the AC
power cord with earth(ground) pin unless it is absolutely required to reduce hum
from the ground loops of the connected devices.
Always ensure that when disconnecting and reconnecting your audio equipment the
mains supply is turned off.
Position the power cord and signal interconnects where they are not likely cause trip
and fall hazard.
Do not use the CDT near water, or place water-filled containers on the CDT. Entry of
liquid into the CDT is hazardous and may cause electric shock and/or fire hazard.
Do not place the unit under direct sunlight or heat source.
Do not remove any covers or try to gain access to the inside. There are no user
adjustments or fuses to change without qualification.
Clean regularly with a damp soft cloth. Do not use any cleaning agents as it might
damage the surface finishing.
The electronics in modern hi-fi equipment is complex and may, therefore, be
adversely affected or damaged by lightning. For protection of the audio system
during electrical storms, disconnect the mains plugs.
AVATAR CDT supports Redbook CD only.