130
Note on playing a source encoded with DTS
•
Noise may be generated at the beginning of playback and
while searching during DTS playback in the AUTO mode. If
so, play in the DTS mode.
3
Example: Stereo
Select the play mode.
(Main unit)
4
Start playback on the selected component.
• For operating instructions, refer to the component’s
manual.
5
Adjust the volume.
(Main unit)
(Remote control unit)
The volume can be adjusted within the range of –80 to +18 dB, in
steps of 0.5 dB. However, when the channel level is set as
described on pages 53, 54 or 137, 138, if the volume for any
channel is set at +0.5 dB or greater, the volume cannot be adjusted
up to 18 dB. (In this case the maximum volume adjustment range
is “18 dB — (Maximum value of channel level)”.)
Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the
“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “DTS”.
(Remote control unit)
M.VOL. -80.0dB
The volume level is displayed on the master volume level display.
Input mode display
• In the AUTO mode
• In the DIGITAL PCM mode
• In the DIGITAL DTS mode
• In the ANALOG mode
Depending on the input signal.
Input signal display
• DOLBY DIGITAL
• DTS
• PCM
The
indicator lights when digital signals are being input
properly. If the
indicator does not light, check whether the
digital input component setup (See pages 60, 61) and connections
are correct and whether the component’s power is turned on.
AL24 processing is activated when PCM signals are played while
the surround mode is set to PURE DIRECT, DIRECT, STEREO,
MULTI CH PURE DIRECT, MULTI CH DIRECT or MULTI CH IN.
Advanced AL24 processing is activated when PCM (2-channel)
signals are played while the surround mode is set to PURE DIRECT
or DIRECT.
DIG.
DIG.
NOTE:
• The
indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
DIG.
• In the EXT.IN mode
Depending on the input signal.
• The
indicator lights when digital signals are
being input with a player that supports HDCD
playback.
HDCD
Depending on the input signal.
• The
indicator lights when the DENON LINK
have been connected and the DSD signals have
been inputted. (See page 20)
DSD
The mode switches as shown below each time the
DIRECT/STEREO button on the Main unit is pressed.
STEREO
DIRECT
• Selecting the external input (EXT. IN) mode
Press the EXT. IN on the main unit or INPUT MODE button
on the remote control unit button to switch the external
input.
(Remote control unit)
(Main unit)
