35
Before performing the Auto Setup procedure
1
Check again that the speakers are securely connected to the AVC-A1XVA.
2
Set the volume to halfway and set the crossover frequency to the maximum or Low pass filter off if your subwoofer can adjust the output
volume and the crossover frequency. Some subwoofers have a standby mode. Be sure to turn this function off before performing the
Auto Setup procedure.
3
The auto setup procedure uses the OSD (on screen display) function, so connect the AVC-A1XVA to a TV, projector, or other monitor.
I
. Connecting the microphone for Auto Setup
1
Connect the microphone for Auto Setup to the Setup Mic jack on the front panel of the unit.
2
Mount the auto setup microphone onto a camera tripod, etc.,
and place it at ear height at the main listening position (*) in
the listening room with the sound receptor facing the ceiling.
When placing the microphone, adjust the height so that the
microphone’s sound receptor is at the height of the ears of
the listener.
Be sure that at the beginning, the measurement is started
with the microphone set up at the main listening position.
NOTE:
• Do not disconnect the microphone until the settings are
completed.
Microphone
