Remote lock function
When connecting an IR receiver, enable the Remote lock function. When
the function is enabled, you can not perform operations with the remote
control unit.
By default, this function is disabled.
.
X
CURSOR DOWN
ENTER
CURSOR UP
Disabling the sensor function of the
remote control unit
1
Press
X
while you press and hold CURSOR DOWN and
ENTER with the unit in standby mode.
2
Use CURSOR UP or CURSOR DOWN to select “RC
LOCK On”.
3
Press ENTER to enter the setting.
The infrared light receiving function is disabled.
Enabling the remote sensor function
1
Press
X
while you press and hold CURSOR DOWN and
ENTER with the unit in standby mode.
2
Use CURSOR UP or CURSOR DOWN to select “RC
LOCK
z
Off”.
(
z
The currently set mode.)
3
Press ENTER to enter the setting.
Infrared light receiving function on the main unit is enabled.
104
