Get
ting Star
ted
Connections
Set
up
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
Pla
ybac
k
1
Set the input source, input mode, surround mode,
room EQ settings and volume to the conditions you
want to store.
2
Press and hold the desired
QUICK SELECT
.
Keep pressing the button until the quick select indicator lights.
• To call out the settings, press
QUICK SELECT
at which the desired
settings were stored.
• The Quick Select name can be changed (
v
page 39).
NOTE
Input sources stored with the quick select function cannot be selected
if they have been deleted at GUI menu “Manual Setup” – “Option
Setup” – “Source Delete” (
v
page 39). In this case, store them
again.
Input Source
Volume
Quick Select 1
DVD
–40 dB
Quick Select 2
TV/CBL
–40 dB
Quick Select 3
VCR
–40 dB
[Quick Select Defaults]
1
Press
CH SELECT
.
2
Press
ui
or
CH SELECT
to select “Fader”.
3
Use
o
p
to adjust the volume of the speakers.
(
o
: front,
p
: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.
1
Press
CH SELECT
.
2
Use
ui
or
CH SELECT
to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use
o
p
to adjust the volume.
b
”OFF” can be set by pressing
o
when the subwoofer’s volume
is set to –12dB.
1
Turn off the power using
<POWER>
.
2
Press
<POWER>
while simultaneously pressing
<STANDARD>
and
<HOME THX CINEMA>
.
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
The surround parameters, tone control, room EQ settings and the
volumes of the different speakers are stored for the individual surround
modes.
Quick Select Function
With this function, the currently playing input source, input mode,
surround mode, room EQ settings and volume can be stored in
the memory.
Fader Function
This function lets you adjust (fade) the sound from all the front or
rear speakers at once.
Channel Level
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
All settings are reset when the microcomputer is reset.
Personal Memory Plus Function
This function sets the settings (input mode, surround mode,
HDMI output mode, Picture Adjust, Audio Delay etc.) last selected
for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
Last Function Memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
