6
NOTE
•
Do not plug in the power cord until all connections have been
completed.
•
When making connections, also refer to the operating instructions of
the other components.
•
Be sure to connect the left and right channels properly (left with left,
right with right).
•
Do not bundle power cords together with connection cables. Doing
so can result in humming or noise.
Cables used for connections
Audio cable (sold separately)
Subwoofer cable
Speaker cable
Optical cable
Audio cable
R
L
R
L
Stereo mini-plug cable
Connections
Connecting the speakers
w
q
w
q
(R)
(L)
IN
Speakers
Subwoofer
with built-in
amplifier
Connecting the speaker cables
Carefully check the left (L) and right (R) channels and + (red) and –
(black) polarities on the speakers being connected to this unit, and be
sure to interconnect the channels and polarities correctly.
1
Peel off about 10 mm of sheathing from
the tip of the speaker cable, then either
twist the core wire tightly or terminate it.
2
Turn the speaker terminal
counterclockwise to loosen it.
3
Insert the speaker cable’s core wire to
the hilt into the speaker terminal.
4
Turn the speaker terminal clockwise to
tighten it.
NOTE
•
Disconnect this unit’s power plug from the power outlet before
connecting the speakers. Also, turn off the subwoofer.
•
Use speakers with an impedance of 4 to 16 Ω. The protection
circuit may be activated if speakers with an impedance other
than specified are used.
•
Connect the speaker cables so they do not stick out of the
speaker terminals. The protection circuit may be activated if the
wires touch the rear panel or if the + and – sides touch each
other (
•
Never touch the speaker terminals while the power supply is
connected. Doing so could result in electric shock.
Pr
epar
ations
Oper
ations
Inf
or
mation
Pr
epar
ations
