11
D-107
4. Pre Amp Unit, Transformer
1) Remove 4 screws
1 0
to detach the Pre Amp Unit.
2) Remove 4 screws
1 1
to detach the Transformer.
1) Pull out the Decoration Ring in the arrow direction.
When disconnecting the cables from terminals of
the Speaker Unit, make it at the position where the
terminals of the Speaker Unit can be seen from the
Back Cabinet. The clamp part of the internal
speaker cables will be disengaged if separated
farther.
3. Back Cabinet, Front Cabinet
1) Remove 10 screws
9
.
2) With holding the Back Cabinet, pull both sides of the Front
Cabinet in the arrow direction.
Note:
Use a rubber hammer etc. to hit the
arrow part
of the Front Cabinet if it’s hard to remove.
3) Push the Front Cabinet to the arrow direction to make a
gap between the Back Cabinet.
4) Cut the wire clamp band near the Front Cabinet, and
disconnect 4 cables on the Pre Amp Unit.
5) Disconnect 2 cables on the bottom of the Pre Amp Unit,
and separate the Back and Front Cabinet.
1 2
1 2
Speaker Unit
Decoration Ring
9
Wire Clamp
Band
Pre Amp Unit
Front Cabinet
Back Cabinet
9
Pre Amp Unit
1 1
1 1
1 0
1 0
1 0
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
