ENGLISH
14
Automatically presetting FM stations
(Auto preset)
This unit can be preset with a total of 99 FM and AM broadcast stations.
NOTE
Auto preset is not possible with AM broadcast stations.
n
Auto presetting with the remote control
Perform this operation when tuned to an FM or AM broadcast
station.
1
Press
[MENU]
.
2
Use
[
ui
]
to select “TUNER SETUP”, then press
[ENTER/MEMO]
or
[
p
]
.
3
Use
[
ui
]
to select “FM AUTO PRESET”, then
press
[ENTER/MEMO]
or
[
p
]
.
4
Press
[ENTER/MEMO]
while “PRESET ENTER” is
fl
ashing.
Broadcast stations are preset automatically.
Canceling auto presetting
Press
[TUNER]
,
<BAND/
2
>
or
[
2
]
.
Broadcast stations whose antenna signal are weak cannot be preset
automatically. If you wish to preset such stations, tune them in
manually.
NOTE
When FM auto preset is performed, the channel currently registered
as the FM preset is deleted, and the newly preset FM broadcast
station is registered to the same number as the deleted channel.
Tuner playback
Tuning in Broadcast Stations
Connect the antenna beforehand (
v
page 9).
1
Press
[TUNER]
or
<BAND/
2
>
to select the reception
band.
FM AUTO
FM MONO
AM
G
About the display
H
When “FM AUTO” is selected ........ “AUTO” is displayed.
When “FM MONO” is selected ...... “MONO” is displayed.
When “AM” is selected .................. The reception mode is not
displayed.
2
Use
[TU –, TU +]
to select the reception band.
When a station is received, the “TUNED” indication will light.
• If the function is set to something other than “TUNER”, press
[TUNER]
to switch the function to “TUNER”.
• The function can also be switched to “TUNER” using
SOURCE
.
n
To tune automatically
Press and hold in
[TU –, TU +]
to tune in stations automatically.
• Stations whose signal is weak cannot be tuned in.
n
To stop auto tuning
Press
[TU –, TU +]
.
A humming sound may be heard when using a TV nearby while
receiving AM programs. If this happens, move the system as far from
the TV as possible.
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control
[BUTTON]
Symbols used to indicate buttons in this manual
[
uio
p
]
[ENTER/MEMO]
[TIME/DISPLAY]
[NUMBER]
[CLEAR/DEL]
[TUNER]
[MENU]
[TU –, TU +]
[CH –, CH +]
[
2
]
SOURCE
<BAND/
2
>
SOURCE
<
8
/-, +/
9
>
1.RCDM38E3̲ENG̲004̲1st.indd 14
1.RCDM38E3̲ENG̲004̲1st.indd 14
2010/05/17 14:17:07
2010/05/17 14:17:07
