PROCEDURE AFTER REPLACING THE U-COM, ETC.
The procedure after replacing the u-COM (microprocessor), flash ROM, etc. is as follows.
PCB Name Ref. No.
Description
Procedure
after Re-
placement
Remark
MAIN
U1
IA3S4 (BAR)
A
WIRELESS MODULE : Tx
POWER
U1
IA3S4 (SUB)
A
WIRELESS MODULE : Rx
Procedure after Replacement
A :
The software has been written. The software is not written at the time of replacement.
B :
The software has been written. The software may need to be rewritten by version updates. Check the
version.
See "
" for information on writing the software.
C :
The software has not been written. The software needs to be written after replacement.
" for information on writing the software.
D :
The software has been written. Be sure to rewrite with the latest software for your service region.
See "
" for information on rewrite the software.
58
Before Servicing
This Unit
Electrical
Mechanical
Repair Information
Updating