4
5.
AP Mode Light:
This LED flashes while DN-200WS is entering AP
Mode and lights solidly when it is in AP Mode. In this mode, DN-
200WS and your wireless device are connected directly over DN-
200WS’s own wireless network. See
Operation
to learn more.
6.
S
TA Mode Light:
This LED flashes while DN-200WS is entering STA
Mode and lights solidly when it is in STA Mode. In this mode, DN-
200WS and your wireless device are connected in an existing wireless
network. See
Operation
to learn more.
7.
Level Knob:
Turn this knob to adjust the volume level of the audio
signal sent to the
outputs
.
8.
Reset Button:
Press this button to reset DN-200WS to its default
status. It will automatically enter AP Mode.
9.
Outputs
(
Balanced XLR
)
:
These outputs send the audio signal from
your wireless device. Use XLR cables to connect these outputs to your
loudspeakers, mixer, etc. See
Setup
for more information.
10.
Outputs
(
Unbalanced 1
/
4”
/
6.35 mm
)
:
These outputs send the audio
signal from your wireless device. Use standard 1/4” (6.35 mm) cables
to connect these outputs to loudspeakers, mixer, etc. See
Setup
for
more information.
