9
S
TA Mode
To set up DN-200W
S
in
S
TA Mode:
1.
Make sure DN-200WS is in AP Mode (as described earlier in
AP Mode
).
2.
On your wireless device, open your web browser and go to
http:
//
192.168.0.1
.
The
S
ettings
page will appear.
3.
Click the
S
TA Network
S
elect
field to select the desired wireless network.
4.
Click the
S
TA
S
ecurity Mode
field to select the desired wireless network’s
security mode.
Note:
If you select
WPA
,
WPA2
,
WPA-Personal
, or
WP
S
, you will need to
enter a password.
5.
Click the
S
TA Network Password
field and enter the password for the
desired wireless network. (Check the
Display Password
checkbox to
reveal the password, or uncheck it to hide it again.)
6.
Click
S
ubmit
(under the
Device Name
field). You will see a webpage
confirming the new settings were sent to DN-200WS.
7.
Disconnect DN-200WS from its power source, and then reconnect it. It will
automatically enter STA Mode using the new wireless network information.
The
S
TA Mode Light
will turn on.
Your wireless device is now connected to DN-200WS. Play audio on your
wireless device to send it from DN-200WS’s
outputs
to your loudspeakers
or mixer.
Important:
After you have gone through
S
teps 3
–
6
once, DN-200WS will
remember that information whenever you enter STA Mode. When you want
to use STA Mode with a different wireless network, repeat
S
teps 1
–
9
.
Note:
To learn how to enter the settings for each mode (wireless network,
password, etc.), see the following
Settings Page
section.
