12
DUBBING
(from deck A to deck B)
• Switch on the
amplifier or receiver.
• Set the Tape Monitor switch on your amplifier or receiver to the TAPE position.
Press the POWER switch to the
ON
position.
load the cassette tape to be played in deck A and the one to be recorded in deck B.
Select the type of tape transport with the REVERSE MODE switch.
Reverse mode
Operation
Dubbing is performed only for one side.
The decks stop when either deck A or B
reaches the end of the tape.
The tape direction is reversed on each
deck when they reach the end of the tape.
(This is convenient for dubbing to a tape
with a different length.)
RELAY
During dubbing of the side facing you, the
deck that first reaches the end of the tape
will stand by until the other deck reaches the
end of the tape, then both decks will reverse
the tape direction together.
(Depending on the manufacturer, the length of
tapes having the same recording time may differ
somewhat. Setting this mode permits the arrangement
of the beginning portion of the opposite
side of the tape.)
To begin normal speed dubbing, press the DUBBING SPEED NORMAL button. The DUB
indicator will light at this time.
To high speed dubbing, press the DUBBING SPEED HIGH button. The HIGH indicator
will light at this time.
To stop dubbing, press the stop of deck A or deck B.
• When deck A is in the playback mode and deck B is in the stop condition, setting deck B
to the recording pause mode will engage the normal speed dubbing pause mode.
Dubbing is then started by pressing the PLAY button.
• When dubbing, the recording level and the Dolby NR coding will be the same as those
of the playback tape, regardless of the positions of the INPUT LEVEL control and the
DOLBY NR button.
• When listening to the playback sound during normal speed dubbing, set the DOLBY NR
button to match the Dolby NR system with which the playback tape was recorded. This
will assure correct sound reproduction, but does not affect the recording.
• The playback sound cannot be heard during high speed dubbing.
Operation using the REC/REC MUTE (•) and REC PAUSE (
II
) buttons of deck B is
permitted during normal speed dubbing.
• Buttons other than the stop button cannot be used during high speed dubbing.
