18" Subwoofer Starter Kit
Thank you for purchasing the 18" Subwoofer Starter kit. The included parts in this kit were
precision cut using CNC machinery for the best possible fit and finish. With a little time and
patience, your finished product will provide years of low frequency bliss. Please follow the
following instructions for the best possible results.
Suggested tools and consumables:
3/4" Medium Density Fiberboard (MDF)
Circular saw/Table Saw
Wood clamps (you can never have too many of these)
Wood glue/Polyurethane glue
Sanding block and/or electric finishing sander
Rag or paper towels
Binding post/terminal cup
Speaker or hook-up wire
First, empty the contents of the package, inspect the parts to ensure everything has been included
and is in good condition. Before gluing anything, do a dry fit of the included parts to familiarize
yourself with the parts and their assembly. This will also give you a chance to ensure that all
pieces have been cut properly. If any parts are missing or damaged please contact our customer
service department at 1-800-338-0531.
1)
Set the enclosure parts out on a flat level surface and ensure that all pieces are free of dust
and debris.
2)
Glue all mating surfaces of the brace components and assemble as shown. Apply enough
pressure to ensure glue is spread through each joint (some glue squeeze-out can be
expected).
