-
31
-
© by DENQBAR GmbH
www.denqbar.com
Exciter
(fig. 1, number 4)
:
Check the oil level
1. put the compactor horizontally
2. open the oil-filler neck (fig. 1, number 4)
3. oil level must reach the beginning of screw thread of the filler neck
4. if necessary fill in engine oil SAE 10W40 (use the hopper).
5. close the oil-filler neck
Change of exciter oil with compactor type DQ-0139 and DQ-0213:
1. open the filler bore (fig. 1, number 4a).
2. cant the compactor as long as the complete oil has leaked.
3. put the compactor horizontal.
4. fill in SAE 10W40 through filler bore SAE 10W40 ( approx. 350 ml type DQ-0139 ) respectively
( 150 ml type DQ-0213 ).
5. close the filler bore (fig. 1, number 4a).
ATTENTION!
Do not fill in too much oil! Otherwise it can
reduce the performance and/or cause damages.
Exciter at compactor type DQ-0215
With this compactor there is no need to change or fill in oil, because the lubrication system works
without oil.
ATTENTION!
Do not clean the exciter with a high pressure washer etc. otherwise water
can infiltrate the system.
Adjusting the V-belt
The V-belt connects the engine and the exciter. Especially with new machines or even after the
change of the v-belt this itself is getting wider and loses purchase. If the V-belt yields more than 10-15
mm on thumb pressure, it is necessary to adjust the V-belt again.
1. Switch off the machine and take off the cover of the belt.
2. Solve the four nuts at the engine.
3. Move back the engine for straining an forward to solve the
V-belt.
4. Put the pulley of the engine parallel to the pulley of the
exciter (a ruler can be helpful). Tighten the four nuts at the
engine again.
5. Fix the cover of the V-belt again.
For adjusting the tension of the v-belt use the clamp screw of
the V-belt. (Fig.1, number 11)
Cleaning of the plate
Stones and dirt, which can get into gaps of the engine system or under the plate, has to be removed
after each use. Furthermore, cylinder cooling fins have to be kept clean in dusty areas, so a
overheating of the engine can be avoided!
To save the environment put a box or a plastic foil under the machine for collecting lost oil.
Take care of the directives of environment safety at disposal of old oil. Old oil is not allowed to
be put into waste, canalisation, landscape or drain.
