10
Error Codes
two-digit code
p to solve it.
he first digit of
e error category, the second digit refers to the problem source:
Error
The
D
signals unexpected events during operation with an error message. The
appearing beside the message refers to the cause of the problem, and may also hel
T
the code refers to th
0x Communication
01, 02, 03, 04, 0
5,
Communication error
06
1x Hardware
Error
10, 11
PROM fault
Internal I2C bus error. EE
18, 19
Internal I2C bus error. DSP fault
2x HDD
Error
20, 21
HDD didn’t respond within timeout
Check Jum
o
pers, connectors, try
ther HDD
22 Drive
fault
23
Not ATA compatible HDD
24
The HDD doesn’t support LBA address
HDD
ing mode
Try other
26
HDD not detected
25, 27, 28, 29, 2A
Drive fault
3x
File System Error
30
Unknown file system (not FAT32)
Create FAT 32 partition
31, 32
Wrong FAT entry
Run Scandisk
33
Broken file cluster chain
Run Scandisk
35
Wrong long filename entry
Run Scandisk
34, 36, 37, 38, 3
oftware error
9,
Unknown s
3C
3A
Invalid path name
3B
eration
Invalid
op
3D Invalid
operation
4x
Data Read Error
40
Data read error from HDD
HDD may have bad sectors, run
Scandisk with full test options
5x
File
Not
Found
50
File Not Found
51, 52, 53
Unknown software error
6x
File Format Error
60
Invalid DMP3 system file header
61
Checksum error, file damaged
62
Wrong system file version
63
File format error
64
Wrong file length
65
ber
Wrong file serial num
7x Disk/SmartMedia
Full
70
HDD is full
71
FAT16 root directory full
72
Formatting
error
8x Unknown
Error
80, 81, 82, 85, 86
Unknown software error
83
SW upgrade list is too long
Cluster size is less than 2K.
Impossible to upgrade the
Firmware
84
Firmware integrity error
Upgrade firmware again
9x User
Cancel
90
Operation cancelled by the user
29
MAN_DH100ix_0200_EN
Summary of Contents for DH100ix
Page 2: ......